Commands on a controller

On the selected controller the following functions become available.

Controller Builder workbench

• Reset the Manipulator
• Open the layer manager
• Move the selection to the other workspace
• Remove the controller
• Move the controller

Layout Builder workbench

• Reset the Manipulator
• Open the layer manager
• Move the selection to the other workspace
• Remove the component
• Set the active adapter
• Move the component
• Calibration

• •Move the component with the Manipulator

Offline Programming workbench

• Activate the Manipulator
• Move the selection to the other workspace
• Set the technology
• Set the active controller program

• Activate the Manipulator
• Move the selection to the other workspace
• Set the active controller program
• Load an existing controller program

• Activate the Manipulator
• Validate team synchronization

Automation Builder workbench

• Activate the Manipulator
• Move the selection to the other workspace
• Set the technology
• Set the active controller program

Drag and Snap operation mode

• Activate the manipulator
• Open the layer manager
• Toggle the Show/Hide
• Change the Operation mode
• Add existing components to the project